Dynamips GUI两SW vlan1 Ping不通
用Dynamips GUI 2.8 模拟两台三层SWISO 是 3640-telco-12.4-13.bin
都只加了现两个NM-16ESW
两台SW用通 F0/1,F1/1相连:
sw-3#show cdp nei
Capability Codes: R - Router, T - Trans Bridge, B - Source Route Bridge
S - Switch, H - Host, I - IGMP, r - Repeater
Device ID Local Intrfce Holdtme Capability Platform Port ID
sw-4 Fas 1/1 132 S I 3640 Fas 1/1
sw-4 Fas 0/1 132 S I 3640 Fas 0/1
sw-4#show cdp nei
Capability Codes: R - Router, T - Trans Bridge, B - Source Route Bridge
S - Switch, H - Host, I - IGMP, r - Repeater
Device ID Local Intrfce Holdtme Capability Platform Port ID
sw-3 Fas 1/1 171 S I 3640 Fas 1/1
sw-3 Fas 0/1 171 S I 3640 Fas 0/1
sw-4#
sw3与sw4 都启了SVI口:
sw-3#show runn int vlan 1
Building configuration...
Current configuration : 77 bytes
!
interface Vlan1
ip address 10.0.0.1 255.255.255.0
no ip route-cache
end
sw-4#show runn int vlan 1
Building configuration...
Current configuration : 77 bytes
!
interface Vlan1
ip address 10.0.0.2 255.255.255.0
no ip route-cache
end
sw3与sw4都关闭了ip routing
每次ping 前都用了 clear arp.
但总是sw3与sw4不能互相Ping 通。
[[i] 本帖最后由 mayeror 于 2010-4-12 09:13 编辑 [/i]]
页:
[1]